Technical

Precautions for the automatic biochemical incubator Turn off the power switch after the incubation. If you do not take out the experimental sample immediately, do not open the door of the incubator.

Precautions for automatic biochemical incubator

1. The automatic biochemical incubator should be installed in a place where the temperature and humidity change is small as much as possible. Use a three-pin plug? The socket should be properly grounded.

2. Before starting the automatic biochemical incubator, you should be fully familiar with and understand the instructions of each component of the supporting instruments and instruments, and master the correct use method.

3. It is strictly forbidden to contain volatile chemical solvents? Explosive gases and flammable gases are placed in the box. Do not use flammable sprays near the incubator? To avoid spark ignition.

4. Always check the gas path for leaks.

5. The automatic biochemical incubator has a power-off protection function, so it takes about one and a half minutes to restart the compressor after it is stopped, so as to better protect the compressor.

6. The distance between the condenser and the wall of the fully automatic biochemical incubator should be greater than 100mm, the side of the box should have a gap of 50mm, and the top of the box should have at least 300mm of space to ensure good heat dissipation.

7. The automatic biochemical incubator should avoid collision and shaking during handling, repair and maintenance, and the maximum inclination should be less than 45 degrees.

8. Turn off the main power supply and the power switch at the rear of the device when it is not used for a long time. ?At the same time, when the biochemical incubator is working, frequent opening of the door should be avoided to keep the temperature stable, and at the same time prevent dust and dirt from entering the work room.

9. The inside and outside of the box should be kept clean every day, and should be cleaned after each use. If you do not use it for a long time, you should always wipe the liner of the box wall and the surface of the equipment to keep it clean and increase the transparency of the glass. Do not wipe the outer surface with acid, alkali or other corrosive solution.

10. After the incubation, turn off the power switch. If you do not take out the experimental sample immediately, do not open the door of the box.

11. The fully automatic biochemical incubator should not be used in abnormal environments such as high voltage, high current and strong magnetic field. It should be strictly implemented in accordance with the electrical safety operation code