News

1. The high-pressure homogenizer is designed to be easy to operate and maintain; you can use distilled water, pure water and detergent to stop circulating cleaning (do not turn on the pressure switch at this time), or remove the pump head to stop manual cleaning.

2. The start/stop control of the machine is located on the side of the machine, which is easy to operate, can be used for emergency switches, and includes thermal and magnetic maintenance of the main motor.

3. The high-pressure homogenizer is equipped with a polished all-stainless steel casing, which can be disassembled for easy inspection and maintenance. Its base stands on four straps with rubber pads.

4. This machine is fed by its own weight and self-suction, and does not need any feeding pump. Only electricity is required and no other equipment (such as water or compressed air) is required. According to the requirements of the sample, gaskets of different materials are used; the standard gasket material is special plastics. The plunger seal uses a special PTFE material that is water lubricated.

5. The refinement effect is more severe. This is because the valve core and valve seat of the working valve are in close contact at the initial position, but a slit is forced out by the material liquid during operation; while the rotating stator of the centrifugal emulsification equipment is in order to meet the requirements of high speed Rotating without generating too much heat, there must be a large gap (relative to the homogenizing valve); at the same time, since the transmission mechanism of the homogenizer is a positive displacement reciprocating pump, theoretically, the homogenizing pressure can be infinite progress, and the higher the pressure, the better the refinement effect.